Skip to content

Water-Damaged Drywall Repair in Wentzville

Wet drywall is not a patch job. If the board has gone soft, it comes out. Here is how we handle the rebuild once the water is stopped.

Start with the source

We repair drywall. We do not stop leaks. Before we cut anything, the water has to be off, the pipe fixed, the roof or window sealed, or the basement seepage dealt with by the people who handle that work. If the board is still getting wet, anything we install will get wet too.

Once the source is handled, tell us what happened and when. A pinhole supply line weeping behind a wall for months is a different job from a burst line that soaked a ceiling overnight.

How to tell the board is finished

  • Brown rings or yellow stains that spread in size.
  • Paint that bubbles, peels or looks wrinkled.
  • Board that feels soft or crumbly when pressed, or has a sag.
  • Tape seams that lift or open.
  • A musty smell that does not go away after the area dries.

Surface stains on board that is still hard and dry can sometimes be sealed and painted. Soft or sagging board cannot. It has lost its strength, and it is the wrong thing to build a repair on.

Leak fixed, wall still wrecked?

Tell us what happened and when. We will tell you how much board has to go.

Our process

We start by marking where the damage ends. We cut out the wet or damaged board past the edge, down to solid, dry material, and haul it out. Then we check the framing exposed behind it. If the studs or the back of the board show growth or staining that worries us, we stop and say so.

With the opening dry, we fit and fasten new board, tape the joints and skim it. A stain-blocking primer goes on before any paint, because water stains bleed through ordinary primer. Finally we match the texture so the repair does not show.

That is the whole job. It is a rebuild, not a touch-up.

A note on mold

We do not test for mold, and we do not do mold remediation. If you smell mustiness or see dark spotting on or behind board, a qualified specialist should assess it before we close the wall back up. We will pause the job and tell you why. Cutting out wet board is a normal part of recovery. Judging what is growing in it is not our trade.

Water damage questions

Can you dry out the wall and leave the drywall in place?

If the board is still hard and only lightly stained, maybe. If it is soft, sagging or bubbled, it comes out. We tell you which after we press on it.

Do you handle mold?

No. If you suspect mold, a qualified specialist should check it before we close the wall. We handle the drywall cutting and rebuilding only.

Do you fix the leak itself?

No. The source has to be repaired by a plumber, roofer or the right trade before we install new board.

Will the repaired area match the rest of the ceiling?

We build the repair to match the existing finish, including texture, and prime with a stain-blocking primer so old marks do not return.

Finished basements and newer houses

Many newer homes around Wentzville have finished lower levels, and drywall in a basement lives close to the slab and the exterior walls. When that board takes on water, it often wicks upward and hides damage behind baseboard and trim.

About 85 percent of homes in the city are owner-occupied by Census QuickFacts figures, and the median home was built around 2007. Newer plumbing and roofing are usually in decent shape, but a failed fitting, an ice dam, a window gasket or a sump failure can still send water where it does not belong. Missouri summers are humid, and damp air does not help a slow leak dry out behind a wall.

When a cut-out is large, we repair the wall in sections so seams land at natural points rather than in the middle of a clean wall. It makes the finish easier to hide.

Time to rebuild the wall?

Ring the shop once the source is handled and the area is dry.

Other repairs we handle

Ring the shopMessage us